features
Editorial
Letters
Radical Renderings
new/used trucks
Reviews
Pictures
Videos
tech
shows
project trucks
exclusives
Wallpaper
Videos
community
Forums
Blogs
Reader's Rides
subscribe
Subscribe
Give a Gift
Subscriber Services
Digital Edition
Back Issues
Latest Articles
2007 Chevy Silverado - Imitator SS
2009 Ford F250 Super Duty Makeover For Under $2,900
2012-2013 Project Trucks - Radical Renderings
Dog Bone Wrenches - Truckin Tough
Hollow Point - 2008 Ford F-650
MAXimum Exposure - Muscle Truck - Issue 7
New Products - Issue 7
Project Lead Sled, Part 1: 2009 Dodge Ram Suspension
Sponsored Links
Home
>
Leather Upholstery Install - New Skins
>
Leather Seats
Leather Upholstery Install - New Skins
Trading in Our Jeans for a Set of Chaps
Photography by Sean P. Holman
Truckin Magazine
,
February, 2009
After laying down the new leather cover over the seat bottom, it was checked for fit.
The new covers attached to the seat in the same fashion as the OEM setup and care was taken to make sure the Velcro attached correctly.
The new covers attached to the seat in the same fashion as the OEM setup and care was take
Next, the hardware and cup holder were removed from the rear seat armrest.
After the stock cover was removed from the armrest, the new leather cover was slid on.
If your armrest is equipped with a cup holder, you will have to cut a hole in the leather cover.
If your armrest is equipped with a cup holder, you will have to cut a hole in the leather
The cup holder was screwed back into the armrest.
Then, the brackets were reattached to the armrest.
Next, the new leather cover was slipped over the rear seatback.
Here, you can see how the Velcro snaps lined up between the cover and the factory seat foam.
Here, you can see how the Velcro snaps lined up between the cover and the factory seat foa
Once the seatback was covered, the armrest was reinstalled.
When the seatback was complete, the lower cushion was reattached and covered.
The seat lever was then reattached to the rear bench.
After the leather was smoothed out and fitting tight, the bench was ready to be reinstalled.
After the leather was smoothed out and fitting tight, the bench was ready to be reinstalle
Next, the front seat was started by removing the armrest.
Once the factory cover was unsnapped from the front seat, it was removed.
«
|
1
|
2
|
3
|
»
|
View Full Article
Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
stumble upon
rss
facebook
twitter
More from Truckinweb:
2004 Chevy Silverado 3500 - 24 Inch Rims - Truckin' Magazine
2009 Chevy Silverado Hybrid - First Look
2005 Chevy Silverado - Sic Crew
1948 Ford F1 Pickup - Tennessee Thunder
Sponsored Links
*Please enter your username
*Please enter your password
*Please enter your comments
Comments:
Not Registered?
Signup Here
Comments
(1024 character limit)