Daneal Frank's '98 F-150 is a hard truck to ignore. Spotted among a sea of customs, Daneal's truck had just the right combination of bold yet simple two-tone paint, inviting interior, and wheel-tucking stance. We decided it had to be featured in the magazine. The fact the truck drove into the show and made its way home without ever touching a trailer made it even sweeter.
Beginning with an extended cab '98 F-150, Daneal and the crew at his shop, Beyond Reality Customs in Port St. Lucie, Florida, began by shaving off all of the distractions, including the door handles, antenna, third brake light, gas filler door, and tailgate handle. Clean and shaved wasn't enough, as the driver door was given the suicide treatment, the tailgate was hinged like a door, and the bedsides were flared an inch on each side. While the welders were fired up, a roll pan was grafted onto the rear of the bed and the taillight pockets were filled. Now, it was time for the serious surgery, as the truck's floor was moved up 7 inches. The rest of the body-drop was administered to the body mounts in the front of the truck and the new bed floor. Bobby, Beyond Reality Customs' bodyman, got the truck's body straight, cleaned, and ready, before Daneal sprayed the body with candy orange and bright white. Daneal used a ton of paint and clear on his truck to make sure the finish looked smooth and deep. For example, the graphics were buried in 2 gallons of clear, and we think it shows. The finish is mirror flat.
The truck's suspension was next on the chopping block, as Jonah at Area 53 Metal Fabrication in Fort Pierce took on the responsibility of cramming 22-inch wheels under each corner. This truck uses CEC hydraulics with stainless hard lines. With the wheels intruding into the engine compartment, along with the relocated computer and all of the wiring, there wasn't much room left under the hood. Undaunted by the space constraint, Daneal was able to retain the factory air conditioning on the 4.6L Ford. The only other modification of the engine bay was the new wheelwells and the removal of the battery; an Optima YellowTop now rides in the cab.
The beautifully painted bed holds two pumps that are used to operate the CCE hydraulics.
In addition to the suicide driver door, the tailgate received some special attention, too.
The Trenz billet wheel and center console trim are two of the remaining pieces of the inte
Moving to the interior of the Ford, Daneal ditched the rear seat and had CoCo's Upholstery, also in Fort Pierce, cover virtually everything in oatmeal tweed and light-brown ostrich leather. Many of the remaining unupholstered interior pieces were painted the same candy orange as the exterior, with a few exceptions: the center console trim and the steering wheel were both replaced with billet pieces from Trenz. The final piece of the puzzle was the audio and video. A Jensen 7-inch in-dash DVD player sends video to a 15-inch monitor in the truck's headliner and sends audio to Jensen components in the doors and dash, providing plenty of entertainment for driving to and from the shows.
We shoot a lot of trucks that arrive to shows on the back of a trailer, but when we see a truck that lays as hard as Daneal's pop up to ride height and drive off, it reminds us of what most truck builders are going for when they first take a Sawzall to their ride. We wish we could say we'd drive a custom truck every day without fear of rock chips and parking lot dings; but we don't own our own paint booth, either.