Project Novakane - Transmission - Clutch - Driveline Conversions

16. Hurst Driveline Conversions included the necessary bolts required to bolt the trans to the bellhousing and each bolt was torqued to spec.
16. Hurst Driveline Conversions included the necessary bolts required to bolt the trans to
17. An important step was making sure the feed and return line going to the hydraulic release bearing were routed through the two notches in the driver-side of the trans.
17. An important step was making sure the feed and return line going to the hydraulic rele
18. Taking a look inside the accessories box from Hurst Driveline Conversions, they included the proper slip yoke, bolts, classic shift knob, instructions, and all of the necessary pigtails for the Tremec's connectors. Now shown but included in most HDC kits is the actual shifter handle. Once we get our trans mounted in the truck, then we will determine the right length and handle angle.
18. Taking a look inside the accessories box from Hurst Driveline Conversions, they includ

19. Brandan Gillogly, also known as the preferred hand model of Truckin’ magazine, then inserted the slip yoke into the Magnum’s output shaft.
19. Brandan Gillogly, also known as the preferred hand model of Truckin’ magazine, then in
20. Brandan’s back-up hand model, Maxwell “New Guy” Matthewson, tried to pick up the slack and inserted the pigtail connector for the electric speedometer sensor.
20. Brandan’s back-up hand model, Maxwell “New Guy” Matthewson, tried to pick up the slack
21. Feeling pretty confident about his abilities, New Guy then inserted the included pigtail for the reverse light indicator.
21. Feeling pretty confident about his abilities, New Guy then inserted the included pigta

22. Completing the hand modeling trifecta, New Guy plugged in the reverse lock out solenoid and our transmission and clutch install was good-to-go.
22. Completing the hand modeling trifecta, New Guy plugged in the reverse lock out solenoi
23. Now all we need to do is install the engine/trans combo into Project Novakane, figure out the shifter location, and get a custom driveshaft installed. Check out those installs next month.
23. Now all we need to do is install the engine/trans combo into Project Novakane, figure

Editors Note: This truck is going to be used as a performance truck and will not be used for towing. Tremec does not endorse the use of their transmissions in trucks that will be used for towing.

SOURCE
RAM Clutches 201 Business Park Boulevard Columbia SC 29203 803-788-6034 www.ramclutches.com	Tremec Transmission Technologies 800-401-9866 734-456-3770 www.ttcautomotive.com
Hurst Driveline Conversions 1340 Specialty Drive Suite A Vista CA 92081 750-598-2244 www.hurst-drivelines.com