Related Photo Galleries
 19. Brandan Gillogly, also known as the preferred hand model of Truckin’ magazine, then inserted the slip yoke into the Magnum’s output shaft. 20. Brandan’s back-up hand model, Maxwell “New Guy” Matthewson, tried to pick up the slack and inserted the pigtail connector for the electric speedometer sensor. 21. Feeling pretty confident about his abilities, New Guy then inserted the included pigtail for the reverse light indicator. 22. Completing the hand modeling trifecta, New Guy plugged in the reverse lock out solenoid and our transmission and clutch install was good-to-go. 23. Now all we need to do is install the engine/trans combo into Project Novakane, figure out the shifter location, and get a custom driveshaft installed. Check out those installs next month.