Here, you can see the results, so far. Check out how the lines angle across the the side of the truck, and see how the Thor logo pops. More layers were shot here and there to place a Thor logo on the tailgate and a Toyota Logo across the rear quarters of the truck (we don't show this, however you can see the end result later in this story). Once all was said and done, Mitch shot PPG 41010 Clear and 3520 Hardener that mixes four-to-one with no thinner. He said this combination creates very little shrink-back and there is no solvent pop. He credits the screw-type Kaeser air compressor for its ability to remove oil and moisture from the air, which prevents fisheye effects on the paint.