2004 Ford E350 - Installing Rear Sight Camera

A Torx head driver was used to remove the passenger side rear taillight cover.
The Rear Sight Cam wires were inserted and dropped into the rear taillight housing.
After removing the rear door wire loom, Darren inserted and drew the Rear Sight Cam RCA wires through the casing.
After removing the rear door wire loom, Darren inserted and drew the Rear Sight Cam RCA wi

A Phillips drive was used to remove the license plate light housing.
The Rear Sight Cam and printed circuit board (PCB) were inserted into the license plate light hole.
The Rear Sight Cam and printed circuit board (PCB) were inserted into the license plate li
After removing the two-sided tape from the 150-degree fisheye Rear Sight Cam lens housing, it was firmly pressed into position, and protected inside the license plate cove.
After removing the two-sided tape from the 150-degree fisheye Rear Sight Cam lens housing,

The factory rear license plate light housing was reinstalled.
Darren inserted the Rear Sight Cam dual input harness into the split-wire loom protective sheathing.
Darren inserted the Rear Sight Cam dual input harness into the split-wire loom protective
The Rear Sight Cam split-wire loom protective sheathing was inserted along the inside of the driver side framerail to the driver side doorstep casing.
The Rear Sight Cam split-wire loom protective sheathing was inserted along the inside of t