Truckin' Magazine
Facebook
Get Adobe Flash player

Photo Gallery

Prev  Next
Rich used a Dremel tool with a sanding drum to remove the flange on the top and bottom of the opening and also to match the curve of the gauge pod exactly. There's a little bit of variation in these cast plastic parts over the years, so expect to do some fine-tuning.
Aeroforce Dual Interceptor Gauges Installation Dremel Tool

Aeroforce Dual Interceptor Gauges Installation - Mind Your Motor

Aeroforce Dual Interceptor Gauges Installation Digital Gauges Aeroforce Dual Interceptor Gauges Installation Parts Aeroforce Dual Interceptor Gauges Installation Overhead Console Aeroforce Dual Interceptor Gauges Installation Gauge Test Aeroforce Dual Interceptor Gauges Installation Gauge Contrast Aeroforce Dual Interceptor Gauges Installation Plastic Pocket
Aeroforce Dual Interceptor Gauges Installation Dremel Tool Aeroforce Dual Interceptor Gauges Installation Wired Leds Aeroforce Dual Interceptor Gauges Installation Glue Gun Aeroforce Dual Interceptor Gauges Installation Gauge Pod Aeroforce Dual Interceptor Gauges Installation Wrapped Wires Aeroforce Dual Interceptor Gauges Installation Pillar Wires
Aeroforce Dual Interceptor Gauges Installation Connector Aeroforce Dual Interceptor Gauges Installation Ground Wires Aeroforce Dual Interceptor Gauges Installation Plugged Gauges Aeroforce Dual Interceptor Gauges Installation Finished Gauges Aeroforce Dual Interceptor Gauges Installation Gauge Face
Trade In Value