2007 Chevrolet Silverado - Fantastic Four

Rubber weather stipping was applied to the edges of the heat shield.

The heat shield was bolted to the airbox tray and to the truck's body.

After the hose was secured to the throttle-body, the intake tube was installed, then a new return hose was attached, and the radiator hose was secured to the tube.

The conical air filter was installed and the mass airflow sensor was plugged in. That was it for the intake.

Here is the Borla exhaust kit.

After removing the factory exhaust, the first section of the Borla exhaust was loosely bolted to the factory pipe and hung from the frame at its other end.

A stand held up the Borla muffler as it was secured loosely to the Borla extension pipe with a clamp.

Then, the tailpipe was attached to the muffler, again loosely with a clamp. The polished tip comes already welded to the tailpipe. Next, all of the clamps were tightened, and the exhaust was finished.

Here are the suspension components from Belltech. There's not much to it, which foreshadowed a quick and easy install.

The wheels, tires, steering linkage, hub, and spindle were removed, and then the brakes hung out of the way.

Next, the hub was bolted to the Belltech spindle, and the assembly was mounted to the upper and lower control arms.