1967 Chevy C10 Suspension Install - Project '67 Nightmare - Tech

Currie Inc. installed a set of Richmond 4.11 ring and pinion gears and an Auburn posi-unit into the GM 12-bolt rearend.	For added strength and looks, a cast aluminum LPW rearend housing cover was installed. The added LPW axle-tube braces will eliminate axle housing deflection.
The CPP Panhard bar mounting bracket was sandwiched between the CPP trailing arm and rear-end housing U-bolt mounting bracket.	The CPP rear brake caliper mounting bracket was aligned and then installed.
The GM 12-bolt rear-end housing was flipped on top of the CPP trailing arm to acquire an instant 5-inch drop. The CPP coil spring will assist with support and ride quality of '67 Nightmare's lowered stance.	The CPP rear brake caliper mounting bracket was aligned and then installed.
After mounting the CPP rear brake hub and rotor over the axle flange, Bill slid the CPP rear brake caliper over the rear brake rotor and secured it.	After mounting the CPP rear brake hub and rotor over the axle flange, Bill slid the CPP rear brake caliper over the rear brake rotor and secured it.
The foundation of '67 Nightmare will ride as good as it looks. Elon will not have to worry about blowing an airbag or developing an airline leak with the CPP 4/5 static drop.

Prev | 1 | 2 | 3 | 4